Högert

Högert flap wheel 80 × 40 × 6 mm

50,00 Kč

Tax included Shipping calculated at checkout.

Model

G40 G60 G80 G100 G120 G150

Shipped from Germany · 30-day right of withdrawal

The Högert flap wheel 80 × 40 × 6 mm is designed for grinding metal on larger, easily accessible surfaces. Its flexible flap construction helps remove paint coatings, rust, sharp edges and burrs. G40, G60, G80, G100, ...

Description

A larger grinding area for metal

The 40 mm-wide grinding zone is suitable for surface grinding, rust spots and weld preparation. A smaller version is easier to guide in confined areas.

Flaps with an aluminium oxide coating

The aluminium oxide abrasive is bonded with synthetic resin to a linen backing. The flaps yield slightly when applied to gentle contours. Excessive pressure increases the load and does not replace the correct grit.

Choose a drill or die grinder correctly

The flap wheel requires a drill chuck or collet suitable for the 6 mm shank. The machine must be suitable for an 80 mm tool diameter and this grinding work. Do not exceed 18,000 rpm; any lower machine limit also applies. The maximum speed is not a requirement for every operation.

Technical specifications

Manufacturer: Högert
Model range: HT8D020–HT8D025
Dimensions: 80 × 40 × 6 mm
Grits: G40, G60, G80, G100, G120 and G150
Shank: 6 mm
Abrasive material: Flaps with aluminium oxide coating
Bond: Synthetic resin
Backing: Linen
Maximum speed: 18,000 rpm

Frequently asked questions

When is the 80 mm version useful?

The 40 mm-wide grinding zone is suitable for larger, easily accessible metal areas. In confined spaces, first check that the tool and machine have enough room to move; a smaller diameter may be more suitable.

Which grit should I choose for working on a weld?

G40 or G60 allow coarser removal; finer versions are used for subsequent smoothing. Do not unintentionally grind away load-bearing weld cross-sections, and observe the requirements for the component.

Can I paint immediately after G150?

That depends on the coating system and the substrate it requires. After grinding, dust, grease and other residues must also be removed appropriately.

Is a 6 mm collet alone sufficient?

The machine, permitted tool diameter and speed must also match. The shank must be held securely. This flap wheel has a maximum speed of 18,000 rpm; a lower machine limit takes precedence.

Technical specifications

Diameter	80 mm
Compatibility	6-mm shank for drills and die grinders
Form supplied	Individual item
Brand	Högert
Material	Metal
Product type	Abrasive
Product group	Drilling and grinding
Suitable materials	Metal
Tool holder	Round shank